DriftNet

Give this sensor a name and tell us where it goes in the array.

Node Name

Position in Array 0 = first node, 1 = second, etc.

Distance from Node 0 (ft) How far from the first node?

You'll enter this code on the ESP32's setup page in a moment. Keep this screen open.

------

Expires in 15:00

Follow these steps exactly:

1 Plug in your ESP32 via USB. The LED will blink rapidly, then pulse slowly. That means it's in setup mode.
2 On your phone or laptop, go to WiFi settings and connect to the network called "DriftNet-Setup" (no password).
3 A setup page will automatically open. If it doesn't, open your browser and go to 192.168.4.1
4 On the setup page: select your home WiFi, enter the password, and enter the 6-digit code from the previous step: ------
5 Hit "Connect Node". The ESP32 will configure itself and reboot. Reconnect your phone to your home WiFi.

Looking for node-01 to come online. This usually takes about 30 seconds after the ESP32 reboots.

Checking...

node-01 is up and scanning. It will start detecting Bluetooth and WiFi signals immediately.

✓

Position 0

Distance 0 ft

Firmware --

Sensor Array